 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| F Semiconductor S4560 Dual high slew rate OP AMP Description The S4560 is dual operational amplifiers which achieve approximately twice the high output current of the S4560, as well as featuring a higher slew rate of 4V/us, a gain band width of 10MHz, and an improved frequency characteristic. Features * * * * * Built-in output short-circuit protection circuit. Internal phase correction. No latch-up Wide same phase mode and differential voltage ranges High gain. low noise Applications * * * * Active filters Audio amplifiers VCOs Other electronic circuits Ordering Information Type NO. S4560 Marking S4560 Package Code SOP-8 Outline Dimensions unit : mm Block Diagram KSI-K004-001 1 S4560 Absolute maximum ratings Characteristic Supply voltage Differential input voltage Input voltage Power Dissipation Operating temperature Storage temperature PCB(50 x50 x1.6 ). Ta = 25 C Symbol VCC VID VIC PD* Topr Tstg Ratings 18 30 Unit V V V mW C C -Vcc~Vcc 550 -40 ~ +85 -55 ~ +125 * Refer to Pd characteristics diagram. The values for the S4560 are those when it is mounted on a glass epoxy Electrical Characteristics (Unless otherwise specified. VCC = +15V, VEE=15V and Ta = 25 C) Characteristic Input offset voltage Input offset current Input bias current Input common mode Voltage Range Maximum Output Voltage Symbol VIOS IIOS IIB VICR VOM Test Condition Rg 10 RL 10 RL 2 Vout=10V, RL 2 Rg 10 Min. Typ. Max. 12 12 10 86 70 0.5 5 50 14 14 13 100 90 6 200 500 - Unit mV nA nA V V V dB dB Large signal Voltage Gain Common mode rejection ratio Power supply rejection ratio Slew Rate Input conversion noise voltage Gain band width product GV CMRR PSRR SR Vn GBW Rg 10 GV=1, RL 2 f=10kHz - 30 4.0 10 150 2.2 - uV/V V/us uV MHz KSI-K004-001 2 S4560 Electrical Characteristic Curves Fig. 1 GV - f (Vcc/VEE=15V,RL=2 ,Ta=25) Fig. 2 VOP-P - f (Vcc/VEE=15V,Ta=25) Fig. 3 IIB - Ta (Vcc/VEE=15V) Fig. 4 VICR - VCC / VEE (Ta=25) / Fig. 5 IQ - VCC / V EE (Ta=25) Fig. 6 IIB - VCC (Ta=25) / KSI-K004-001 3 S4560 These AUK products are intended for usage in general electronic equipments(Office and communication equipment, measuring equipment, domestic electrification, etc.). Please make sure that you consult with us before you use these AUK products in equipments which require high quality and/or reliability, and in equipments which could have major impact to the welfare of human life(atomic energy control, airplane, spaceship, traffic signal, combustion central, all types of safety device, etc.). AUK cannot accept liability to any damage which may occur in case these AUK products were used in the mentioned equipments without prior consultation with AUK. KSI-K004-001 4 |
Price & Availability of S4560
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |